01Introduction
Overview
Satellite communication systems combine RF hardware, real-time signal processing and networked software, deployed in places that are hard to reach and expensive to visit.
We work on the software side of that system: the embedded platforms in terminals and modems, the control of the RF chain, the management of remote fleets and the test automation that makes RF behaviour reproducible.
02Engineering challenges
What makes this sector difficult.
- 01
Constrained, high-latency links
Geostationary links add hundreds of milliseconds of latency and bandwidth is expensive. Protocols, updates and management traffic have to be designed for it.
- 02
Remote, unattended sites
Terminals are installed where nobody can press a reset button. Updates must be fail-safe, and devices must recover on their own.
- 03
Software tightly coupled to RF hardware
Modem, front-end and antenna control span FPGAs, DSPs and embedded processors. Interfaces between them are easy to get subtly wrong.
- 04
Testing with real RF
Meaningful tests need signal generators, channel emulators and spectrum analysers. Without automation, RF testing stays slow, manual and hard to reproduce.
03Typical systems
The systems we work on.
- VSAT terminals and satellite modems
- Software-defined radio and RF front-end control
- Hub and gateway software
- Network management systems (NMS)
- Remote software and configuration management for terminal fleets
- Production and RF test automation
04How we contribute
Capabilities applied to this sector.
- 01Embedded Software EngineeringEmbedded Linux platforms, drivers and control software for terminals, modems and RF front-ends.
- 03Systems IntegrationIntegration of terminals, hubs and network management, designed for latency, loss and intermittent connectivity.
- 05Quality & AutomationAutomated RF and production test benches driving instruments over SCPI, integrated in CI.
- 07Cyber Resilience & CRA ComplianceSecure boot, signed fail-safe updates and alignment with the RED cybersecurity requirements and the Cyber Resilience Act.
05Regulatory context
Standards and regulation that shape the work.
Listed as the regulatory context engineering work in this sector must respect. They are not certifications held.
- DVB-S2 / DVB-S2X
- Physical-layer standards widely used for broadband satellite links.
- Radio Equipment Directive, delegated act (EU) 2022/30
- Cybersecurity requirements for connected radio equipment, applicable since August 2025 (harmonised standards EN 18031-1/-2/-3).
- 3GPP non-terrestrial networks
- Integration of satellite access into 5G standards from Release 17 onwards.
- Cyber Resilience Act (EU) 2024/2847
- Cybersecurity requirements for products with digital elements placed on the EU market.
Contact
Engineering challenges in communications?
Describe the system and its constraints. We will tell you honestly whether and how we can help.
Start a conversation